This application benchmarks the various cryptographic primitives offered by mbed TLS.
## Pre-requisites
To build and run this example the requirements below are necessary:
* A computer with the following software installed:
* [CMake](http://www.cmake.org/download/).
* [yotta](https://github.com/ARMmbed/yotta). Please note that **yotta has its own set of dependencies**, listed in the [installation instructions](http://armmbed.github.io/yotta/#installing-on-windows).
* A serial terminal emulator (e.g. screen, pySerial, cu).
* An [FRDM-K64F](http://developer.mbed.org/platforms/FRDM-K64F/) development board, or another board supported by mbed OS (in that case you'll have to substitute frdm-k64f-gcc with the appropriate target below).
* A micro-USB cable.
* If your OS is Windows, please follow the installation instructions [for the serial port driver](https://developer.mbed.org/handbook/Windows-serial-configuration).
## Getting started
1. Connect the FRDM-K64F to the computer with the micro-USB cable, being careful to use the micro-usb port labeled "OpenSDA".
2. Navigate to the mbedtls directory supplied with your release and open a terminal.
3. Set the yotta target:
```
yotta target frdm-k64f-gcc
```
4. Check that there are no missing dependencies:
```
$ yt ls
```
If there are, yotta will list them in the terminal. Please install them before proceeding.
5. Build mbedtls and the examples. This will take a long time if it is the first time:
```
$ yt build
```
6. Copy `build/frdm-k64f-gcc/test/mbedtls-test-example-benchmark.bin` to your mbed board and wait until the LED next to the USB port stops blinking.
7. Start the serial terminal emulator and connect to the virtual serial port presented by FRDM-K64F. For settings, use 115200 baud, 8N1, no flow control. **Warning:** for this example, the baud rate is not the default 9600, it is 115200.
