nixpkgs-suyu/nixos/doc/manual/administration/declarative-containers.xml
2018-05-01 19:57:09 -04:00

60 lines
2.5 KiB
XML
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

<section xmlns="http://docbook.org/ns/docbook"
xmlns:xlink="http://www.w3.org/1999/xlink"
xmlns:xi="http://www.w3.org/2001/XInclude"
version="5.0"
xml:id="sec-declarative-containers">
<title>Declarative Container Specification</title>
<para>
You can also specify containers and their configuration in the hosts
<filename>configuration.nix</filename>. For example, the following specifies
that there shall be a container named <literal>database</literal> running
PostgreSQL:
<programlisting>
containers.database =
{ config =
{ config, pkgs, ... }:
{ <xref linkend="opt-services.postgresql.enable"/> = true;
<xref linkend="opt-services.postgresql.package"/> = pkgs.postgresql96;
};
};
</programlisting>
If you run <literal>nixos-rebuild switch</literal>, the container will be
built. If the container was already running, it will be updated in place,
without rebooting. The container can be configured to start automatically by
setting <literal>containers.database.autoStart = true</literal> in its
configuration.
</para>
<para>
By default, declarative containers share the network namespace of the host,
meaning that they can listen on (privileged) ports. However, they cannot
change the network configuration. You can give a container its own network as
follows:
<programlisting>
containers.database = {
<link linkend="opt-containers._name_.privateNetwork">privateNetwork</link> = true;
<link linkend="opt-containers._name_.hostAddress">hostAddress</link> = "192.168.100.10";
<link linkend="opt-containers._name_.localAddress">localAddress</link> = "192.168.100.11";
};
</programlisting>
This gives the container a private virtual Ethernet interface with IP address
<literal>192.168.100.11</literal>, which is hooked up to a virtual Ethernet
interface on the host with IP address <literal>192.168.100.10</literal>. (See
the next section for details on container networking.)
</para>
<para>
To disable the container, just remove it from
<filename>configuration.nix</filename> and run <literal>nixos-rebuild
switch</literal>. Note that this will not delete the root directory of the
container in <literal>/var/lib/containers</literal>. Containers can be
destroyed using the imperative method: <literal>nixos-container destroy
foo</literal>.
</para>
<para>
Declarative containers can be started and stopped using the corresponding
systemd service, e.g. <literal>systemctl start container@database</literal>.
</para>
</section>