Installing NixOS into a VirtualBox guest is convenient for users who want to try NixOS without installing it on bare metal. If you want to use a pre-made VirtualBox appliance, it is available at the downloads page. If you want to set up a VirtualBox guest manually, follow these instructions: Add a New Machine in VirtualBox with OS Type "Linux / Other Linux" Base Memory Size: 768 MB or higher. New Hard Disk of 8 GB or higher. Mount the CD-ROM with the NixOS ISO (by clicking on CD/DVD-ROM) Click on Settings / System / Processor and enable PAE/NX Click on Settings / System / Acceleration and enable "VT-x/AMD-V" acceleration Click on Settings / Display / Screen and select VBoxVGA as Graphics Controller Save the settings, start the virtual machine, and continue installation like normal There are a few modifications you should make in configuration.nix. Enable booting: = "/dev/sda"; Also remove the fsck that runs at startup. It will always fail to run, stopping your boot until you press *. = false; Shared folders can be given a name and a path in the host system in the VirtualBox settings (Machine / Settings / Shared Folders, then click on the "Add" icon). Add the following to the /etc/nixos/configuration.nix to auto-mount them. If you do not add "nofail", the system will no boot properly. The same goes for disabling rngd which is normally used to get randomness but this does not work in virtual machines. { config, pkgs, ...} : { security.rngd.enable = false; // otherwise vm will not boot ... fileSystems."/virtualboxshare" = { fsType = "vboxsf"; device = "nameofthesharedfolder"; options = [ "rw" "nofail" ]; }; } The folder will be available directly under the root directory.