Previously all card-specific stuff was scattered across xserver.nix
and opengl.nix, which is ugly. Now it can be kept together in a single
card-specific module. This required the addition of a few internal
options:
- services.xserver.drivers: A list of { name, driverName, modules,
libPath } sets.
- hardware.opengl.package: The OpenGL implementation. Note that there
can be only one OpenGL implementation at a time in a system
configuration (i.e. no dynamic detection).
- hardware.opengl.package32: The 32-bit OpenGL implementation.
Fixes#2379.
The new name was a misnomer because the values really are X11 video
drivers (e.g. ‘cirrus’ or ‘nvidia’), not OpenGL implementations. That
it's also used to set an OpenGL implementation for kmscon is just
confusing overloading.
release.nix and release-combined.nix current hardcode the systems which
they are built for. This change introduces an argument to the
expressions called supportedSystems, which allows the builder to choose
which architectures he wants to build. By default, this uses the same
linux x86_64 and i686 architectures.
The Tarsnap module is now far more flexible, allowing individual
archives with individual options to be specified at will, allowing
granular backup schedules, etc.
Signed-off-by: Austin Seipp <aseipp@pobox.com>
This reverts commit 6eaced3582. Doesn't
work very well, e.g. if you actually have the FUSE module loaded. And
in any case it's already fixed in NixOps.
Otherwise, when switching from systemd 203 to 212, you get errors like:
Failed to stop remote-fs.target: Bad message
Failed to stop systemd-udevd-control.socket: Bad message
...
These fail to mount if you don't have the appropriate kernel support,
and this confuses NixOps' ‘check’ command. We should teach NixOps not
to complain about non-essential mount points, but in the meantime it's
better to turn them off.
By default, socat only waits 0.5s for the remote side to finish after
getting EOF on the local side. So don't close the local side, instead
wait for socat to exit when the remote side finishes.
http://hydra.nixos.org/build/10663282
This fixes several problems in the dhcpcd service:
* A segfault during startup, due to a race with udev (dhcpcd would get
an ADD event from udev, causing it to re-add an interface that it
already had, leading to a segfault later on).
* A hang/segfault processing "dhcpcd rebind" (which NixOS calls after
waking up from suspend).
Also, add "lo" to the list of ignored interfaces. It usually ignores
"lo", but apparently not when it gets an ADD event from udev.
Upstream has not been tagging new versions for a long time, but we need
compatibility with newer kernels. The 0.6.2 versions already have a bunch of
backported compatibility patches, but 3.14 kernels need even more.
Also, the git versions have fixed a bunch of crashes and other bugs, so perhaps
we should just bite the bullet and just use recent git versions (as sometimes
upstream recommends, when people run into bugs).
This adds a new "boot.zfs.useGit" boolean option, so that a user can
easily opt into using the git versions.
